02/20004-57DocuPrint N2125 REP 9.1, REP 9.2Repair-AdjustmentInitial IssueREP 9.1 Fan AssemblyParts List on PL 9.1RemovalWARNINGTurn the power off and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Left Cover (REP 1.2).4. Remove the Front Cover Assembly (REP 1.6).5. Remove the Left Front Cover (REP 1.7).6. Remove the Top Cover Assembly (REP 1.4).7. Open the Rear Cover Assembly.8. Remove the Left Plate Assembly (REP 1.11).9. Disconnect P/J283 connected to the Fan Assembly from the LVPS PWB.10. Release the harness of the Fan Assembly from the two clamps on the printer (Figure 1).11. Remove the four screws securing the assembly to the printer (Figure 1).12. Remove the Fan (Figure 1).Figure 1 Fan AssemblyReplacement1. Reinstall the components in the reverse order.REP 9.2 System Controller PWBParts List on PL 10.1RemovalCAUTIONThese components are susceptible to electrostatic discharge. Observe all ESD procedures toavoid damage.WARNINGTurn the power off and disconnect the Power Cord.1. Remove the Interface Cover Assembly (REP 1.1).2. Disconnect host cables connected to the System Controller PWB.3. Disconnect P/J18 and P/J13 from the System Controller PWB (Figure 1).4. Remove the five screws that secure the System Controller PWB to the printer (Figure 1).5. Move the System Controller PWB toward the rear to disconnect P/J14 from the PrintEngine Controller PWB (REP 9.3).6. Remove the System Controller PWB from the printer (Figure 1).Figure 1 System Controller PWB
