02/20004-44 DocuPrint N2125REP 6.3Initial IssueRepair-AdjustmentREP 6.3 Fuser Harness AssemblyParts List on PL 6.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Left Cover (REP 1.2).4. Remove the Front Cover Assembly (REP 1.6).5. Remove the Left Front Cover (REP 1.7).6. Remove the Left Plate Assembly (REP 1.11).7. Remove the Plate Handle (REP 1.12).8. Open Rear Door.9. Remove the Fuser Assembly (REP 6.2).10. Remove the Top Cover Assembly (REP 1.4).11. Remove the MBF Chute Assembly (REP 4.1).12. Remove the Paper Handler Assembly (REP 5.1)13. Remove the Transport Chute Assembly (REP 6.1)14. Remove the Print Cartridge Top Guide Assembly (REP 7.2).15. Remove the Print Engine Controller PWB (REP 9.3)16. Remove the Main Motor Assembly (REP 8.1)17. Remove the LVPS PWB (REP 9.5)18. Remove the Drive Gear Assembly (REP 8.2)19. Unplug the P/JPRB (red) from the HVPS PWB (REP 10.6).20. Remove the screw that secures the HVPS Housing to the printer (Figure 1).21. Remove the HVPS.22. Pull the Fuser Harness Assembly from the left side of the printer (Figure 1).23. Remove the two screws that secure the Fuser Harness Assembly to the printer (Figure 1).24. Remove the Fuser Harness Assembly.Figure 1 Fuser Harness AssemblyReplacement1. Reinstall the components in the reverse order.
