02/20004-72 DocuPrint N2125REP 10.10, REP 10.11Initial IssueRepair-AdjustmentREP 10.10 Direction SolenoidParts List on PL 14.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Offset Catch Tray (REP 10.1).2. Remove the Exit Tray Extension (REP 10.2).3. Remove the Exit Tray (REP 10.3).4. Turn the Offset Catch Tray upside down.5. Remove the Lower Cover (REP 10.5).6. Hold open the Rear Cover.7. Remove the Inner Exit Chute Assembly (REP 10.6).8. Disconnect P/J228 from the Direction Solenoid (Figure 1).9. Remove the two screws that secure the solenoid to the Inner Exit Chute Assembly (Figure1). Remove the Solenoid.Figure 1 Direction SolenoidReplacement1. Reinstall the components in the reverse order.REP 10.11 Exit Sensor AssemblyParts List on PL 14.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Offset Catch Tray (REP 10.1).2. Remove the Exit Tray Extension (REP 10.2).3. Remove the Exit Tray (REP 10.3).4. Turn the Offset Catch Tray upside down.5. Remove the Lower Cover (REP 10.5).6. Hold open the Rear Cover.7. Remove the Inner Exit Chute Assembly (REP 10.6).8. Release the four locking tabs and remove the sensor (Figure 1).9. Disconnect P/J227 from the Exit Sensor Assembly (Figure 1).Figure 1 Exit Sensor AssemblyReplacement1. Reinstall the components in the reverse order.
