02/20007-28 DocuPrint N2125Offset Catch TrayInitial IssueWiring DataOffset Catch TrayWiring Diagrams and Signal InformationThis section of the manual contains a Block Diagram for the N2125 OCT. The Block Diagramshows the interconnections of the major subsystems within the printer. The remainder of thissection divides the Block Diagram into individual block diagrams to better illustrate the electri-cal relationships between components and assemblies within the Offset Catch Tray. Each wirein the block diagram is tagged with a signal name, and each wire is terminated at both endswith a pin number.Block Diagram1. OCT Block Diagram2. Print Engine Controller PWB <=> OCT PWB (Figure 3) (Table 2)3. OCT PWB <=> Stack Full Sensor, OCT Home Sensor, OCT Exit Sensor Assembly andDirection Solenoid (Figure 4) (Table 3)4. OCT PWB <=> Drive Motor Assembly and Offset Motor Assembly (Figure 5) (Table 4)Location of P/J ConnectorsUse the P/J table (Table 1) and the P/J map (Figure 1) to locate a specific P/J connector withinthe Feeder and Cassette.1. Locate the P/J connector number in the first column of the table.2. Locate the corresponding coordinates in the second column, such as I7 or J7.3. Go to the map.4. Cross-reference the letter and number of the P/J coordinates with the letters and numberson the map.5. The P/J connector is located within the area where the coordinates cross.
