02/20002-55DocuPrint N2125 RAP 66Status Indicator Repair Analysis ProceduresInitial IssueRAP 66 Envelope Feeder Jam (E2)Envelopes early of late to the Registration Sensor.ProcedureRemove all envelopes. Check the Envelope Feeder and Printer for contamination, paperscraps, or other obstructions. The printer and Envelope Feeder is clean and free ofobstructions.Y NClean feeder and remove all obstructions.Check the Feed Belts. Check for dirt or contamination on the top side and the under side of thebelt. Both sides of the belt are clean.Y NReplace the Feed Belts (REP 13.17).Enter Diagnostics and select Component Test. Scroll to Confirm EBF Clutch and press Enter.You can hear the clutch energize.Y NGo to RAP 63.Scroll to Main Motor Operation and press Enter. Scroll to Confirm EBF Clutch. Watch the FeedBelts and Feed Rollers and press Enter. The Feed Belts and Feed Rollers all rotate.Y NEnsure the Envelope Feeder is installed properly and is contacting the printer drive gear.The Envelope Feeder is installed correctly.Y NReinstall the Envelope Feeder correctly.Remove the Envelope Feeder and check the feeder drive gears. All gears are in goodcondition and operating properly.Y NReplace the gears as necessary (PL 12.2).Replace the Envelope Feed Clutch (REP 13.12). If the problem persists, Replace theEnvelope Feeder PWB (REP 13.3).Perform RAP 32 to check the Registration Sensor. The Registration Sensor is operatingcorrectly.Y NReplace the Registration Sensor (REP 5.4).Replace the Print Engine Controller PWB (REP 9.3).
