02/20004-73DocuPrint N2125 REP 10.12, REP 10.13Repair-AdjustmentInitial IssueREP 10.12 Stack Full Sensor ActuatorParts List on PL 14.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Offset Catch Tray (REP 10.1).2. Remove the Exit Tray Extension (REP 10.2).3. Remove the Exit Tray (REP 10.3).4. Turn the Offset Catch Tray upside down.5. Remove the Lower Cover (REP 10.5).6. Hold open the Rear Cover.7. Remove the Inner Exit Chute Assembly (REP 10.6).8. Remove the Static Eliminator (REP 10.9).9. Remove the Stack Full Actuator from the two retaining clips (Figure 1).Figure 1 Stack Full Sensor ActuatorReplacement1. Reinstall the components in the reverse order.REP 10.13 Stack Full SensorParts List on PL 14.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Offset Catch Tray (REP 10.1).2. Remove the Exit Tray Extension (REP 10.2).3. Remove the Exit Tray (REP 10.3).4. Turn the Offset Catch Tray upside down.5. Remove the Lower Cover (REP 10.5).6. Hold open the Rear Cover.7. Remove the Inner Exit Chute Assembly (REP 10.6).8. Remove the Offset Catch Tray PWB (REP 10.7).9. Disconnect P/J225 from the Stack Full Sensor (Figure 1).10. Release the four locking tabs that secure the sensor (Figure 1). Remove the sensor.Figure 1 Stack Full SensorReplacement1. Reinstall the components in the reverse order.
