02/20004-41DocuPrint N2125 REP 5.6Repair-AdjustmentInitial IssueREP 5.6 Rubber Registration RollParts List on PL 5.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Front Cover Assembly (REP 1.6).4. Remove the Left Front Cover (REP 1.7).5. Remove the MBF Chute Assembly (REP 4.1).6. Remove the Paper Handler Assembly (REP 5.1).7. Remove the Registration Clutch (REP 5.5).8. Remove the two E-rings that secure the two Registration Gears (Figure 1).9. Remove the E-ring from the left end of the Metal Registration Shaft (Figure 1).10. Release the two registration springs from the Metal Registration Roll (Figure 2).11. Squeeze and hold the Upper Chute and Inlet Chute together. Align the hole in the chutewith the Boss on the Left Bearing. Remove the Left Bearing from the Metal RegistrationRoll (Figure 1).12. Lift the Torsion Spring and slide the Right Bearing out. Squeeze and hold the UpperChute and Inlet Chute together and align the hole in the chute with the Boss on the RightBearing. Remove the Right Bearing (Figure 1).13. Slide the Metal Registration Shaft to the right and remove the assembly (Figure 1).14. Remove the left and right bearings from the Rubber Registration Roll (Figure 3).15. Lift the right end of the Rubber Registration Roll and remove (Figure 3).Figure 1 Registration Roll
