Xerox DocuPrint N2125 Service Manual

Also see for DocuPrint N2125: Product reference guide Specification sheet User guide User guide Service manual

Contents

Xerox DocuPrint N2125 Service Manual Manual pdf 150 page image

02/20004-50 DocuPrint N2125REP 6.9Initial IssueRepair-AdjustmentREP 6.9 Fuser Upper Cover Assembly/ Heat RodParts List on PL 6.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove Fuser Assembly (REP 6.2).2. Disconnect P/J274 from the left end of the Fuser Assembly (Figure 1).3. Remove the four screws securing the right and left end cover on the Fuser Assembly (Fig-ure 1).4. Remove both covers while carefully disengaging the wiring harness on each end (Figure1).NOTE: The Heat Rod must be removed before the Upper Cover Assembly to avoid break-age.5. Invert the Fuser Assembly to access the Fuser Heat Rod (Figure 2)6. Remove the three screws securing the Fuser Heat Rod and Harness (Figure 2).NOTE: Avoid touching the glass rod with your fingers. Oil from your skin will contaminateand shorten the life of the Heat Rod.7. Carefully remove the Heat Rod by lifting the right end sliding it out to the right side of theHeat Roll (Figure 3).8. Return the Fuser Assembly to it’s right side up position (Figure 4).9. Remove the four screws and the Fuser Upper Cover (Figure 4).Figure 1 Fuser AssemblyFigure 2 Fuser Heat RodFigure 3 Heat RodFigure 4 Fuser Upper CoverReplacement1. Reinstall the components in the reverse order.