02/20004-71DocuPrint N2125 REP 10.8, REP 10.9Repair-AdjustmentInitial IssueREP 10.8 Motor Drive AssemblyParts List on PL 14.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Offset Catch Tray (REP 10.1).2. Remove the Exit Tray Extension (REP 10.2).3. Remove the Exit Tray (REP 10.3).4. Turn the Offset Catch Tray upside down.5. Remove the Lower Cover (REP 10.5).6. Hold open the Rear Cover.7. Remove the Inner Exit Chute Assembly (REP 10.6).8. Remove the two screws that secure the motor to the Inner Exit Chute Assembly (Figure1).9. Disconnect P/J210 from the Offset Catch Tray PWB and remove the motor (Figure 1).Figure 1 Motor Drive AssemblyReplacement1. Install the motor with both tabs touching the plastic standoffs.2. The ground wire on top and the earth plate at the bottom should be on the outside (Figure1).3. Reinstall the components in the reverse order.REP 10.9 Static EliminatorParts List on PL 14.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Offset Catch Tray (REP 10.1).2. Remove the Exit Tray Extension (REP 10.2).3. Remove the Exit Tray (REP 10.3).4. Turn the Offset Catch Tray upside down.5. Remove the Lower Cover (REP 10.5).6. Hold open the Rear Cover.7. Remove the Inner Exit Chute Assembly (REP 10.6).8. Remove the three screws that secure the Static Eliminator to the Inner Exit Chute (Figure1).9. Remove the Static Eliminator (Figure 1).Figure 1 Static EliminatorReplacement1. Reinstall the components in the reverse order.
