Xerox DocuPrint N2125 Service Manual

Also see for DocuPrint N2125: Product reference guide Specification sheet User guide User guide Service manual

Contents

Xerox DocuPrint N2125 Service Manual Manual pdf 147 page image

02/20004-47DocuPrint N2125 REP 6.7Repair-AdjustmentInitial IssueREP 6.7 Mid 1 & Mid 2 Roll AssembliesParts List on PL 7.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Left Cover (REP 1.2).4. Remove the Front Cover Assembly (REP 1.6).5. Remove the Left Front Cover (REP 1.7).6. Remove the Top Cover Assembly (REP 1.4).7. Remove the Rear Cover Assembly (REP 1.8).8. Remove the Interlock Cover (REP 1.10).9. Remove the Left Plate Assembly (REP 1.11).10. Remove the Exit Chute Assembly (REP 6.4).11. Lift the Static Eliminator Assembly and remove (Figure 1) (See REP 6.8 - step 6).12. Remove the Stack Full Actuator (REP 6.8).13. Release the locking tab and remove the Exit-17 Gear from the defective Roll Assembly(Figure 1), (Figure 2), or (Figure 3).14. Remove the Exit-32 Gear from the Exit Chute Assembly (Figure 1).15. With a small screwdriver carefully release the locking tab that secures the Exit Bearings tothe Exit Chute Assembly (Figure 1), (Figure 2), or (Figure 3).16. Remove the Roll Assembly together with the Exit Bearing from the Exit Chute Assembly(Figure 1), (Figure 2), or (Figure 3).17. Remove the left Exit Bearing from the Roll Assembly.Figure 1 Exit 17 & Exit 32 Gears