02/20004-46 DocuPrint N2125REP 6.5, REP 6.6Initial IssueRepair-AdjustmentREP 6.5 Exit Motor AssemblyParts List on PL 7.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Remove the Front Cover Assembly (REP 1.6).4. Remove the Left Front Cover (REP 1.7).5. Remove the Left Cover (REP 1.2).6. Remove the Left Plate Assembly (REP 1.11).7. Remove the Top Cover Assembly (REP 1.4).8. Remove the Rear Cover Assembly (REP 1.8)9. Remove the Interlock Cover (REP 1.10).10. Remove the Exit Chute Assembly (REP 6.4).11. Remove the two screws that secure the Exit Motor Assembly to the Exit Chute Assembly(Figure 1).12. Remove the Motor (Figure 1).Figure 1 Exit Motor AssemblyReplacement1. Reinstall the components in the reverse order.REP 6.6 Stack Full SensorParts List on PL 7.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove Tray 1.2. Remove the Left Interface Cover Assembly (REP 1.1).3. Front Cover Assembly (REP 1.6).4. Remove the Left Front Cover (REP 1.7).5. Remove the Top Cover Assembly (REP 1.4).6. Open Rear Cover.7. Remove the Static Eliminator Assembly (See REP 6.8 - step 6).8. Remove the Stack Full Actuator (REP 6.8).9. Disconnect P/J311 from the Stack Full Sensor (Figure 1).10. Disengage the five hooks securing the Stack Full Sensor to the Exit Chute Assembly (Fig-ure 1) Remove the Sensor (Figure 1)Figure 1 Exit SensorReplacement1. Reinstall the components in the reverse order.
