Activity Management Reports and Lists 9-5Appendix9RX ReportThis report is used to check if documents were sent normally from the sending party, or ifdocuments were received normally by this machine.You can set whether or not to automatically print an RX report. (See ‘Setting AutomaticOutput of an RX Report,’ on p. 7-6.)NOTE• The default setting for RX Report is “Off”. (See ‘Setting Automatic Output of an RX Report,’ on p. 7-6.)1 REPORT NAME An “RX REPORT” is printed when the sending of documents is completed normally,and also when a receiving error occurs.2 MESSAGE A message describing the reception result is printed.3 JOB NO. The 4-digit number, that is automatically assigned when a receiving document isaccepted, is printed.4 DEPARTMENT ID If Department ID Management is set, the Department ID is printed.5 DESTINATIONADDRESSThe telephone number of the sending party is printed to the first 20 digits.6 SUBADDRESS A subaddress is printed if one is specified.7 DESTINATION ID The name of the remote party is printed.8 ST. TIME The date and time (24-hour clock display) at which the documents started to be sentare printed.9 USAGE T The time taken (minutes and seconds) from start to end of sending is printed.10 PGS. The number of pages of the original that were sent normally to the remote party isprinted.11 RESULT When sending of the documents ended normally, “OK” is printed.When a sending error occurred, “NG” is printed.If a sending error occurred, the page number of the page in which the error occurred,and also the error code number are printed.RECEPTION OKJOB NO.DESTINATION ADDRESSPSWD/SUBADDRESSDESTINATION IDST. TIMEUSAGE TPGS.RESULT500203/05 13:0200’141OK03/05 2001 MON 13:03 FAX 035 4892 5997 . 001CANON✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽ ✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽RX REPORTRX Report
