Setting Transmission Functions 5-33Setting and Storing Custom Fax Settings5● To set transmission error redial:Press “TX Error Resend” → press the desired item → press “OK.”“Error and 1st page”: Auto Redial takes place if a sending error occurs. The first page ofthe document and also the error page and subsequent pages are resent.“All pages”: Auto Redial takes place if a sending error occurs. All pages of the documentare resent.“Off”: Redialing does not take place if a sending error occurs.NOTE• To cancel the setting procedure, press “Cancel.”4 When all the settings are complete, press “Done,” and press “OK.”5 Press “Done.”The specified mode is set.Press “Done” repeatedly until the Fax Basic Features screen appears.Setting the Stamping ConditionsYou can specify whether or not to stamp the documents after they are sent, or scanned intomemory.IMPORTANT• This setting is available only when the Feeder (DADF-H1) is attached.NOTE• Specify whether or not to stamp the documents using the Fax Basic Features screen. (See‘Stamping Sent or Scanned Originals (Stamping Original),’ on p. 2-17.)• The default setting is “Direct & Memory TX.”
