Activity Management Reports and Lists9-4Appendix9Multiple Communication Result ReportThis report is used to check whether documents were sent normally to the intendeddestination when a sequential broadcast transmission was performed.You can set whether or not to automatically print a sending result report after sendingdocuments by fax. (See ‘Setting Automatic Output of a TX Report,’ on p. 7-3.)NOTE• The default setting for printing of the TX result report is “For error only.”• You can also print a TX report with an image of the sent original attached to it. (See ‘SettingAutomatic Output of a TX Report,’ on p. 7-3.)1 JOB NO. A 4-digit number, that is automatically assigned when the sending document isaccepted, is printed.2 PGS. The number of pages of the original that were normally sent to the remote party isprinted.3 DEPARTMENT ID If Department ID Management is set, the Department ID is printed.4 TX/RXINCOMPLETEThe telephone number of the sending destination to which you have not finishedsending is printed. If there is no applicable destination, “_ _ _” is printed.5 TRANSACTIONOKThe telephone number of the sending destination to which you have finished sendingis printed. If there is no applicable destination, “_ _ _” is printed.6 ERROR When a sending error occurs, the telephone number of the sending destination isprinted. If there is no applicable destination, “_ _ _” is printed.00141[ 11] 1234567890-----[ 10] 0987654321Canon CANADACanon U.S.A03/05 2001 MON 13:43 FAX 035 4892 5997 CANONJOB NO.PGS.TX/RX INCOMPLETETRANSACTION OKERROR. 001✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽ ✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽✽MULTI TX/RX REPORTMulti TX/RX Report
