02/20002-20 DocuPrint N2025/N2825RAP 11, RAP 12Initial IssueStatus Indicator Repair Analysis ProceduresOpen the Rear Cover and cheat the Rear Cover Interlock Switch. Scroll to Exit MotorFwd L then press Enter [4]. After a few seconds press Offline [0]. Scroll to Exit MotorRev and press Enter [4]. The Exit Motor rotates smoothly in both directions.Y NReplace the Duplex Assembly (REP 9.1).Replace the Exit Assembly (PL 13.1).Check the Exit Assembly for obstructions. Clean all rollers in the Exit Assembly. ReplaceRear Cover Assembly (PL 6.1), if necessary.Clean the Fuser Assembly. Replace the Fuser Assembly (REP 5.1), if necessary.RAP 12 System Controller IsolationProcedureSwitch the printer power off. Disconnect all cables connected to the rear of the System Control-ler PWB. Remove the Left Side Cover (REP 1.1). Remove all options from the System Control-ler PWB. Switch the printer power on. The printer boots up correctly and Ready is dis-played on the Control Panel (if no options are installed, follow the No path).Y NSwitch the printer power off. Remove then reinstall the System Controller PWB (REP 8.1)to reseat the connection with the Print Engine Controller PWB. Switch the printer poweron. The printer boots up correctly and Ready is displayed on the Control Panel.Y NReplace the System Controller PWB (REP 8.1).Problem Solved.Switch the printer power off. Reinstall one of the removed options or cables. Switch the printerpower on. The printer boots up correctly and Ready is displayed on the Control Panel.Y NReplace the option or cable just installed.Repeat the last step with the next option or cable until the problem is found.A B C
