02/20004-27DocuPrint N2025/N2825 REP 4.3, REP 4.4Repair-AdjustmentInitial IssueREP 4.3 Registration ClutchParts List on PL 5.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Open the Rear Cover.2. Remove the Fuser Assembly (REP 5.1).3. Open the Top Cover and remove the Print Cartridge. Cover the cartridge to protect it fromlight.4. Remove Tray 1.5. Remove the MBF Assembly (REP 2.1).6. Remove the Left Side Cover (REP 1.1).7. Remove the Top Cover Assembly (REP 1.3).8. Remove the HVPS Cover (REP 1.6).9. Remove the Paper Transport Assembly (REP 4.1)10. Remove the E-ring that secures the Registration Clutch to the Rubber Registration Roll(Figure 1).11. Remove the Registration Clutch (Figure 1).Figure 1 Registration ClutchReplacement1. Reinstall the components in the reverse order.REP 4.4 Metal Registration RollParts List on PL 5.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Open the Rear Cover.2. Remove the Fuser Assembly (REP 5.1).3. Open the Top Cover and remove the Print Cartridge. Cover the cartridge to protect it fromlight.4. Remove Tray 1.5. Remove the MBF Assembly (REP 2.1).6. Remove the Left Side Cover (REP 1.1).7. Remove the Top Cover Assembly (REP 1.3).8. Remove the HVPS Cover (REP 1.6).9. Remove the Paper Transport Assembly (REP 4.1)10. Remove the Registration Clutch (REP 4.3).11. Release the left and right Registration Springs (Figure 1).12. Remove the left and right E-rings (Figure 1).13. Remove the Gear from the right end of the Metal Registration Roll (Figure 1).14. Remove the right and left bearings (Figure 1).15. Lift the right end of the Metal Registration Roll. Slide the roll to the right to free the left endof the roll. Then slide the roll to the left to remove (Figure 1).Figure 1 Metal Registration RollReplacement1. Reinstall the components in the reverse order.
