02/20007-40 DocuPrint N2025/N2825Duplex Assembly, Offset Catch TrayInitial IssueWiring Data30. Print Engine Controller PWB <--> Duplex Interface PWB <--> Duplex PWB <--> DuplexMotor Assembly, Exit Motor Assembly and Duplex Sensor Assembly Offset Catch TrayLocation of P/J ConnectorsUse the P/J table below (Table 1) and the P/J map (Figure 1) on the next page to locate a spe-cific P/J connector within the Feeder and Cassette.1. Locate the P/J connector number in the first column of the table (Table 1).2. Locate the corresponding coordinates in the second column, such as I7 or J7.3. Go to the map (Figure 1).4. Cross-reference the letter and number of the P/J coordinates with the letters and numberson the map.5. The P/J connector is located within the area where the coordinates cross.Table 2 Signal names for the Duplex Interface PWB <--> Duplex PWB pathSignal Name DescriptionA-CLK The signal that commands "Low" speed rotation in clockwise of theDuplex Motor Assembly and the Exit Motor Assembly.B-CLK The signal that commands "High" speed rotation in clockwise of theDuplex Motor Assembly and the Exit Motor Assembly.A-ON The signal activates the Motor, synchronizing with A-CLK signal.B-ON The signal activates the Motor, synchronizing with B-CLK signal.A-DIR The signal that commands the direction of rotation.DUP-SNS The signal from the Sensor Assembly Dup. This signal is "Low" when thepaper exists in the Duplex Assembly.Table 1 P/J LocationsConnector Coordinate DescriptionP/J 514 E6 Connects the STK-0 Harness to the OCT PWB.P/J 515 F7 Connects the Offset Motor Assembly to the OCT PWB.P/J 516 J7 Connects the inside the Offset Motor Assembly.P/J 517 F6 Connects STK Motor Harness to the OCT PWB.P/J 518 C6 Connects the STK Motor Harness to the OCT Motor Assembly.P/J 519 J9 Connects the Printer Assembly (Duplex I/F PWB) to the GateSolenoid.P/J 520 E6 Connects the STK FLJM Harness to the OCT PWB.P/J 521 D5 Connects the STK FLJM Harness to the Stack Full Sensor.P/J 523 G7 Connects the STK FLJM Harness to the OCT Sensor.P/J 524 E6 Connects the STK COV OP Harness to the OCT PWB.P/J 525 D5 Connects the STK COV OP Harness to the Interlock Switch.P/J 526 B8 Connects the STK-0 Harness to the Duplex I/F PWB.
