02/20004-17DocuPrint N2025/N2825 REP 2.10, REP 2.11Repair-AdjustmentInitial IssueREP 2.10 Tray 1 Feed RollParts List on PL 4.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the MBF Assembly (REP 2.1).2. Turn the MBF up-side down.3. Release the Tray 1 Feed Solenoid.4. Rotate the Feed Rolls up.5. Press locking tab that secures the Left Roll Core (Figure 1).6. Slide the Left Roll Core to the left (Figure 1).7. Slide the Feed Roll to the left and remove (Figure 1).8. If replacing the envelope feed rolls, press the locking tabs and remove the two envelopefeed rolls (Figure 1).Figure 1 Tray 1 Feed RollReplacement1. Reinstall the components in the reverse order. Note the arrows on the side of the enve-lope feed rolls. The arrows indicate the direction of rotation.NOTE: Note the arrows on the side of the envelope feed rolls. The arrows indicate thedirection of rotation.REP 2.11 Tray 1 Retard Holder AssemblyParts List on PL 3.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Open the Top Cover and remove the Print Cartridge. Cover the cartridge to protect it fromlight.2. Remove Tray 1.3. Remove the MBF Assembly (REP 2.1).4. Remove the Retard Chute Assembly (REP 3.1).5. From the rear, release the two locking tabs (Figure 1).6. Remove the Retard Holder Assembly from the front (Figure 1).Figure 1 Retard Holder AssemblyReplacement1. Reinstall the components in the reverse order.
