02/20006-93DocuPrint N2025/N2825 GP 6.1, GP 6.2General Procedures / InformationInitial IssueGP 6.1 How to Run a System Controller Test Print1. Switch the printer power on.2. When the display indicates "Ready", press the [1] or [5] key until "Print Menu" is displayed.3. Press the [2] or [6] key until "Test Print" is displayed.4. Press Enter. The printer will print two test print and return to the "Ready" condition.NOTE: If Duplex is set to On, it will print one double-sided print.GP 6.2 How to run a IOT Test Print1. Enter IOT Diagnostics - while switching on the printer power, press and hold keys [2] and[6] until the message "IOT" is displayed. When “IOT” is displayed or the control panel,release keys [2] and [6] and press “Enter”. The system will now enter the DiagnosticsMode.2. Main Menu / Component Test appears on the Display Panel.3. Using key [1] or [5], scroll until “Test Print” is displayed.Select the “Input Tray” for feeding:4. Using key [2] or [6], scroll until “Input Tray” is displayed.5. Using key [3] or [7], scroll to select the tray for paper feed.6. Press “Enter” to lock in the selection.Select the “Output Tray”:7. Using key [2] or [6], scroll until “Output Tray” is displayed.8. Using key [3] or [7], scroll to select either “Standard” or “OCT”.9. Press “Enter” to “Lock-In” the selection.Selecting Duplex:10. Using key [2] or [6], scroll until “Duplex”.11. Using key [3] or [7], select either “On” or “Off”.12. Press “Enter” to “Lock-in” the selection.Print Pattern:13. Using key [2] or [6] scroll until “Print Pattern” is displayed.14. Press “Enter”. Printer will begin delivering test prints. Printing will continue until outputquantity reaches 999 or key [0] is pressed and held for 1 second.
