Xerox DocuPrint N2025 Service Manual

Also see for DocuPrint N2025: Product reference guide Specification sheet User guide Supplementary guide Install guide

Contents

Xerox DocuPrint N2025 Service Manual Manual pdf 139 page image

02/20004-29DocuPrint N2025/N2825 REP 5.1, REP 5.2Repair-AdjustmentInitial IssueREP 5.1 Fuser AssemblyParts List on PL 6.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.WARNINGIf the printer has been in operation, the Fuser may be hot.1. Open the Rear Cover.2. Move the Fuser Locking Lever to the left (as viewed from the rear) (Figure 1).3. Lift the left tabs to disconnect P/J174 then lift both the left and right tabs to remove (Figure1).Figure 1 Fuser AssemblyReplacement1. Reinstall the components in the reverse order.NOTE: Install the locating pins first.REP 5.2 Stack Full SensorParts List on PL 6.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Open and remove the Rear Cover (REP 1.9).2. Remove the four screws that secure the Lower Exit Chute Assembly (Figure 1). Removethe assembly.3. Remove the four screws that secure the Upper Exit Chute (Figure 2). Remove the top ofthe Rear Cover.4. Release the two locking tabs that secure the Stack Full Sensor Holder to the Rear Cover(Figure 2).5. Remove the Stack Full Sensor Holder and Actuator from the Rear Cover.6. Release the three locking tabs and remove the sensor from the holder (Figure 3).7. Disconnect P/J507 from the Stack Full Sensor (Figure 2).Figure 1 Lower Exit Chute