Xerox DocuPrint N2025 Service Manual

Also see for DocuPrint N2025: Product reference guide Specification sheet User guide Supplementary guide Install guide

Contents

Xerox DocuPrint N2025 Service Manual Manual pdf 142 page image

02/20004-32 DocuPrint N2025/N2825REP 5.5Initial IssueRepair-AdjustmentREP 5.5 Exit Roll AssemblyParts List on PL 6.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Open the Rear Cover.2. Remove the Rear Cover (REP 1.9).3. Remove the four screws that secure the Lower Exit Chute Assembly (Figure 1). Removethe assembly.4. Remove the four screws that secure the Upper Exit Chute. Remove the chute (Figure 2).5. Remove the E-ring that secures the right end of the Upper Exit Roll Assembly (Figure 3).6. Release the three locking tabs and remove the Gear Z15 from Upper Exit Roll Assembly(Figure 3).7. Remove the left and right bearings from the Exit Roll (Figure 3).8. Remove the two paper tabs from the shaft (Figure 3).9. Move the Exit Roll Shaft to the left until the right end is free of the Rear Cover. Removethe Exit Roll (Figure 3).10. Remove the E-ring that secures the right end of the Lower Exit Roll Assembly (Figure 4).11. Release the three locking tabs and remove the Gear Z22 from Lower Exit Roll Assembly(Figure 4).12. Remove the left and right bearings from the Exit Roll (Figure 4).13. Move the Exit Roll Shaft to the left until the right end is free of the Rear Cover (Figure 4).Remove the Exit Roll.Figure 1 Lower Exit ChuteFigure 2 Upper Exit ChuteFigure 3 Upper Exit Roll Assembly