Xerox DocuPrint N2025 Service Manual

Also see for DocuPrint N2025: Product reference guide Specification sheet User guide Supplementary guide Install guide

Contents

Xerox DocuPrint N2025 Service Manual Manual pdf 161 page image

02/20004-51DocuPrint N2025/N2825 REP 9.1, REP 9.2Repair-AdjustmentInitial IssueREP 9.1 Duplex AssemblyParts List on PL 13.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Open the Rear Cover.2. Remove Left Cover (REP 1.1).3. Pull the top of the Duplex Assembly away from the printer to disengage the two hookssecuring the unit (Figure 1).4. Pull the Duplex Assembly out and up to remove (Figure 1).Figure 1 Duplex AssemblyReplacement1. Reinstall the components in the reverse order.REP 9.2 Exit Motor AssemblyParts List on PL 13.1RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the Duplex Assembly (REP 9.1).2. Remove the two screws that secure the Motor Assembly to the Duplex Assembly (Figure1).NOTE: There are different type and lengths of screws removed in Step 3.3. Remove the harness from the cable clamp (Figure 1).4. Disconnect P/J510 from the Duplex Assembly PWB (Figure 1).5. Rotate the connector sideways and push the connector through the hole in the Duplexframe (Figure 1).6. Remove the motor cover (Figure 1).7. Remove the two screws that secure the Exit Motor to the holder assembly (Figure 1).Figure 1 Exit Motor AssemblyReplacement1. Reinstall the components in the reverse order.