02/20004-72 DocuPrint N2025/N2825REP 11.16, REP 11.17Initial IssueRepair-AdjustmentREP 11.16 Retard Holder AssemblyParts List on PL 11.3RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the printer from the 500 Sheet Feeder (REP 11.1).2. Remove the paper tray from the feeder.3. Remove the Front Cover (REP 11.2).4. Remove the Left Cover (REP 11.3).5. Remove the 500 Sheet Feed Head Assembly (REP 11.9).6. Remove the Retard Chute (REP 11.13).7. From the back of the Retard Chute Assembly, release the two locking tabs (Figure 1).8. Remove the Retard Roll from the front of the chute (Figure 1).Figure 1 Retard Holder AssemblyReplacement1. Reinstall the components in the reverse order.REP 11.17 Retard Turn Roll AssemblyParts List on PL 11.2RemovalWARNINGSwitch off the power and disconnect the Power Cord.1. Remove the printer from the 500 Sheet Feeder (REP 11.1).2. Remove the paper tray from the feeder.3. Remove the Front Cover (REP 11.2).4. Remove the Left Cover (REP 11.3).5. Remove the 500 Sheet Feed Head Assembly (REP 11.9).6. Remove the Retard Chute (REP 11.13).7. Press the locking tab and remove the Turn Gear from the left end of the shaft (Figure 1).8. Remove the E-ring from the right end of the shaft (Figure 1).9. Remove both the right and left bearings (Figure 1).10. Remove the shaft (Figure 1).Figure 1 Turn Roll AssemblyReplacement1. Reinstall the components in the reverse order.
