Initial SettingsInitial SettingsConfiguring the IP Address on the Printer .................................................................................................................. 496Configuring the IP Address Using imagePROGRAF Device Setup Utility ................................................ 508Configuring the IP Address Using the Printer Control Panel ........................................................................ 496Configuring the IP Address Using ARP and PING Commands ..................................................................... 497Configuring TCP/IPv6 Network Settings ...................................................................................................................... 499Configuring the Printer Driver Destination (Windows) ........................................................................................... 499Configuring the Printer Driver Destination (Mac OS) ............................................................................................. 500Configuring the Printer's TCP/IP Network Settings With RemoteUI ................................................................ 500Configuring the IP Address on the PrinterConfiguring the IP Address on the PrinterYou must configure the printer's IP address before using the printer in a TCP/IP network.The printer's IP address is configured automatically when you install the printer driver following the instructions in theSetup Guide.Configure the IP address by using imagePROGRAF Device Setup Utility, the printer Control Panel, or ARP or PINGcommands, if the IP address is changed, or if you change the printer connection mode to a network connection. Fordetails on configuring the IP address, refer to the following topics.• Configuring the IP Address Using imagePROGRAF Device Setup Utility ➔P.508 (Windows)• Configuring the IP Address Using the Printer Control Panel ➔P.496• Configuring the IP Address Using ARP and PING Commands ➔P.497Important• If you use a DHCP server for automatic assignment of the printer's IP address, printing may no longer be possibleafter the printer is turned off and on. This is because an IP address different from before has been assigned. Thus,when using DHCP server functions, consult your network administrator and configure the settings in one of the follow-ing ways.• Configure the setting for dynamic DNS updatingIn the printer menu, either set DNS Dync update to On, or activate the setting Enable DNS Dynamic Update inRemoteUI.(See "Menu Settings.") ➔ P.459(See "Configuring the Printer's TCP/IP Network Settings With RemoteUI.") ➔ P.500• Configure the setting for assignment of the same IP address each time the printer starts upNote• We recommend configuring the printer's IP address even if you will use the printer in networks other than TCP/IP net-works. Configuring the printer's IP address enables you to use RemoteUI to configure the network settings and man-age the printer with a web browser.For details on RemoteUI, see "Using RemoteUI." ➔ P.494Configuring the IP Address Using the Printer Control PanelConfiguring the IP Address Using the Printer Control PanelThis topic describes how to configure the printer's IP address on the Control Panel.1 On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-lect the Settings/Adj. tab ( ).Configuring the IP Address on the Printer iPF685User's GuideNetwork Setting Initial Settings496Downloaded from ManualsPrinter.com Manuals
