Pack the printer1 Disconnect the power cord and interface cable.Important• Turn off the printer before you unplug it. It may damage the printer if you unplug it before it is off and transferit in that state. If you accidentally unplug the printer, plug it in again, reinstall the ink tanks, and follow thisprocedure again.2 Tape down printer covers to secure them, in the reverse or-der of tape removal during installation.3 Remove the Stand by reversing the installation procedure, when it was attached to the printer.4 Disassemble and repackage the Stand by following the installation procedure in reverse.5 Repack the Roll Holder, Holder Stopper, and printer in shipping materials, and then package them in a shippingbox.Reinstalling the PrinterReinstalling the PrinterThe basic workflow for reinstalling the printer is as follows.For detailed instructions, see the Setup Guide.Assemble the stand (optional)1 If you are using the optional Stand, assemble the Stand by refer-ring to the Printer Stand Setup Guide included with the Stand.iPF685 Reinstalling the PrinterUser's GuideMaintenance and Consumables Other Maintenance621Downloaded from ManualsPrinter.com Manuals
