HP-GL/2 problemsHP-GL/2 problemsWith HP-GL/2, printing is misaligned ............................................................................................................................. 651Lines or images are missing in printed HP-GL/2 jobs. ........................................................................................... 651Lines are printed too thick or thin in HP-GL/2 print jobs ..................................................................................... 651HP-GL/2 jobs are printed in monochrome (or color) ............................................................................................. 652Printed colors of lines are inaccurate during HP-GL/2 printing ........................................................................ 652HP-GL/2 jobs are printed 6 mm larger than specified .......................................................................................... 652HP-GL/2 jobs are printed at maximum size, even if a standard size is specified ...................................... 652HP-GL/2 printing takes a long time ................................................................................................................................ 652The printer stops when printing a HP-GL/2 job (the carriage stops moving) ............................................. 652With HP-GL/2, printing is misalignedWith HP-GL/2, printing is misalignedCause Corrective ActionThe plotter origin is incorrect. Check the printing commands.Set Detect img size to Command priority or Detected size in the Control Pan-el menu.The Margin setting in the Control Panel menu is in-correct.Adjust the Margin setting values in the Control Panel menu.Lines or images are missing in printed HP-GL/2 jobs.Lines or images are missing in printed HP-GL/2 jobs.Cause Corrective ActionThe memory is full. Check the size of the data in the print job.An HP-GL/2 command not supported by this printer wasreceived.Check the print job and settings.The printer has received print data that includes HP RTLcommands when Auto Rotate is On in the Control Panelmenu.In the Control Panel, set Auto Rotate to Off and print again.(See "Menu Settings.") ➔ P.459The plotter origin is incorrect. Set Detect img size to Command priority or Detected size in the ControlPanel menu.(See "Menu Settings.") ➔ P.459Oversize in the Control Panel menu is set to Off. Set Oversize to On in the Control Panel menu.(See "Menu Settings.") ➔ P.459Lines are printed too thick or thin in HP-GL/2 print jobsLines are printed too thick or thin in HP-GL/2 print jobsCause Corrective ActionThe Width setting in the Control Panel menuis incorrect.Change the Width setting configured in Pen no. of the Palette A or Palette B selectedin the Control Panel menu.(See "Menu Settings.") ➔ P.459ThickenFineLines in the Control Panel menuis set to Off.If fine lines are printed faintly, setting ThickenFineLines to On will print the lines moredistinctly.(See "Menu Settings.") ➔ P.459The Ln wdth correct setting in the ControlPanel menu is incorrect.Change the Ln wdth correct setting in the Control Panel menu.(See "Menu Settings.") ➔ P.459iPF685 With HP-GL/2, printing is misalignedUser's GuideTroubleshooting HP-GL/2 problems651Downloaded from ManualsPrinter.com Manuals
