Cause Corrective ActionThe loaded paper is too small. (See "Removing the Roll from the Printer.") ➔ P.380(See "Removing the Roll Holder from Rolls.") ➔ P.3832. Replace the roll with a roll 10 inches wide or larger.(See "Attaching the Roll Holder to Rolls.") ➔ P.372(See "Loading Rolls in the Printer.") ➔ P.375The printer will resume printing.Press ▲ or ▼ to select Stop Printing, and then press the OK button."Remove paper and check pap. size"Cause Corrective ActionA sheet has come out of the printer during printing. 1. Press the Release Lever back and remove the paper.2. Reload the sheet, aligning it with the guide on the right.3. Pull the Release Lever forward.4. If "Not finished printing. Finish printing remaining jobs?" is shown on theDisplay Screen, press the OK button.Printing will resume, starting from the page on which the error occurred.(See "Loading Sheets in the Printer.") ➔ P.394PaprWidth MismatchPaprWidth MismatchCause Corrective ActionWhen Detect Mismatch in the Control Panel menu is setto Pause or Hold Job, the width of the loaded roll doesnot match the width specified in Fit Roll Paper Width inthe printer driver.Press ▲ or ▼ to select Print, and then press the OK button to resume print-ing.However, note that this error may cause paper jams and affect the printingquality.Press ▲ or ▼ to select Stop Printing, and then press the OK button.Follow these steps to replace the roll to match the width specified in the print-er driver.1. Press ▲ or ▼ to select Change Paper, and then press the OK button.(See "Removing the Roll from the Printer.") ➔ P.380(See "Removing the Roll Holder from Rolls.") ➔ P.3832. Replace with paper of the width configured in the printer driver.(See "Attaching the Roll Holder to Rolls.") ➔ P.372(See "Loading Rolls in the Printer.") ➔ P.375The printer now starts printing the print job.Make sure the roll width selected in the dialog box displayed when you selectFit Roll Paper Width in the printer driver matches the width of the roll loadedin the printer, and then try printing again.Paper size not detected.Paper size not detected.Cause Corrective ActionPaper has been loadedaskew, or warped paperhas been loaded.Follow these steps to reload the roll.1. Press the OK button and reload the paper.(See "Loading Rolls in the Printer.") ➔ P.3752. Pull the Release Lever forward.PaprWidth Mismatch iPF685User's GuideError Message Messages regarding paper662Downloaded from ManualsPrinter.com Manuals
