Follow these steps to configure the settings.1 Load the paper.• Attaching the Roll Holder to Rolls ➔P.372• Loading Rolls in the Printer ➔P.375• Loading Sheets in the Printer ➔P.3942 On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-lect the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.3 Press the OK button.The Set./Adj. Menu is displayed.4 Press ▲ or ▼ to select Adjust Printer, and then press the OK button.5 Press ▲ or ▼ to select Feed Priority, and then press the OK button.6 Press ▲ or ▼ to select Adj. Priority, and then press the OK button.7 Press ▲ or ▼ to select Automatic, Print Quality, or Print Length, and then press the OK button.Automatic Banding AdjustmentAutomatic Banding AdjustmentIf printed images are affected by banding in different colors across the sheet, execute Adj. Quality for automatic ad-justment of the paper feed amount.There are two modes of automatic adjustment to correct banding: Auto(GenuinePpr) and Auto(OtherPaper). In eithermode, the printer prints and reads a test pattern for automatic adjustment of the feed amount.• Auto(GenuinePpr)Use this mode with paper identified in the Paper Reference Guide.(See "Types of Paper.") ➔P.362• Auto(OtherPaper)Use this mode with paper not in the Paper Reference Guide, or if Auto(GenuinePpr) does not eliminate banding.(See "Types of Paper.") ➔P.362Automatic Banding Adjustment iPF685User's GuideAdjustments for Better Print Quality Adjusting the feed amount582Downloaded from ManualsPrinter.com Manuals
