Menu SettingsMenu SettingsMenu items are as follows.The printer menu is classified into regular menu items available when no print job is in progress and menu during print-ing items only available while printing is in progress. see "Printer Menu Operations." ➔P.448Regular menu Menu during printingPaper Menu Not displayedInk Menu The same Ink Menu as normal is displayed.Job Menu The same Job Menu as normal is displayed.Set./Adj. Menu A limited Set./Adj. Menu containing the following items is displayed.• Adj. Fine Feed (*1)• Printer Info*1: Only displayed in the menu during printing. Not displayed in the regular menu.For instructions on selecting menu items, see "Menu Operations." ➔P.449For details on the displayed menu hierarchy, see "Menu Structure." ➔P.452Paper MenuThe Paper Menu is not displayed during printing.Setting Item Description, InstructionsLoad Paper Select either sheets or rolls and load the paper.Eject Paper Choose this item before removing loaded paper.Chg. Paper Type (*1) Change the type of paper loaded. (See "Changing the Type of Pa-per.") ➔ P.378Chg. Paper Size Change the size of paper loaded. (See "Specifying the PaperLength.") ➔ P.380 (See "Paper Sizes.") ➔ P.362ManageRemainRoll Choose On to print a barcode at the end of a roll before you removeit. The printed barcode can be used in managing the amount of rollpaper left. Choose Off if you prefer not to print the barcode.(See "Keeping Track of the Amount of Roll Paper Left.") ➔ P.385Paper Details (The type of paperis displayed here.)(*1)Head Height Adjust the Printhead height. (See "Troubleshooting Paper Abrasionand Blurry Images.") ➔ P.580Skew Check Lv. If you print on Japanese paper (washi) or other handmade paperthat has an irregular width, choose Loose for a higher skew detec-tion threshold, or choose Off to disable skew detection. However, ifpaper is loaded askew when detection is Off, note that paper jamsor Platen soiling may occur.Cutting Mode Specify whether or not to cut with the standard round-bladed cutter.If you choose Automatic, the roll will be cut automatically using theCutter Unit, depending on the printer driver settings.Select Eject to prevent printed documents from falling immediatelyafter printing such as when you wait for the ink to dry, etc. Manualprints lines at the cut position instead of cutting after printing.(See "Specifying the Cutting Method for Rolls.") ➔ P.388Cut Speed Choose the cutting speed. The preset selection represents the opti-mal cutting speed for the type of paper. We recommend keeping thepreset cutting speed.If you use adhesive paper, choosing Slow helps prevent adhesivefrom sticking to the cutter and keeps the cutter sharp.Trim Edge First Selects whether or not to automatically cut the leading edge of theroll paper when roll paper is loaded.iPF685 Menu SettingsUser's GuideControl Panel Printer Menu459Downloaded from ManualsPrinter.com Manuals
