Paper not aligned with right guide.Paper not aligned with right guide.Cause Corrective ActionWhen paper was loaded, it was not aligned with the guide on the right side. Follow these step to reload a sheet.1. Push the Release Lever back.2. Pull out the sheet.3. Pull the Release Lever forward.4. Reload the sheet, aligning it with the guide on the right.Cannot detect paprCannot detect paprCause Corrective ActionThe printer could not detect the paper. Reload the paper as follows.1. Remove the paper and press the OK button.2. Reload the paper.(See "Loading Sheets in the Printer.") ➔ P.394(See "Loading Rolls in the Printer.") ➔ P.375Leading edge detection error.Leading edge detection error.Cause Corrective ActionThe leading edge of the paper cannot be detected. Follow these step to reload a sheet.1. Push the Release Lever back.2. Reload the sheet straight, in the correct position.(See "Loading Sheets in the Printer.") ➔ P.394Paper cutting failed.Paper cutting failed.Cause Corrective ActionThere are sheets left on theEjection Guide.1. Push the Release Lever back and remove the paper.2. Load the paper.3. Pull the Release Lever forward.4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, pressthe OK button.Printing will resume, starting from the page on which the error occurred.(See "Loading Rolls in the Printer.") ➔ P.375There is a foreign object bythe Output Tray, obstructingthe Cutter Unit.1. Lift the Top Cover and remove the foreign object.2. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, pressthe OK button.Printing will resume, starting from the page on which the error occurred.You are not using the printerunder the recommended en-vironmental conditions forthe paper.Use the printer only where the recommended environmental conditions for the paper are met. Note thatvarious environmental conditions are recommended for various types of paper. For details on the recom-mended environmental conditions for paper, see Paper Reference Guide."(See "Displaying the Paper Reference Guide.") ➔ P.365You are using paper that isnot compatible with automat-ic cutting.1. Specify Manual as the cutting method and use scissors or a cutting tool to cut the roll.(See "Specifying the Cutting Method for Rolls.") ➔ P.388For information about paper that is compatible with automatic cutting, see the Paper ReferenceGuide.(See "Displaying the Paper Reference Guide.") ➔ P.3652. Push the Release Lever back and remove the paper.Paper not aligned with right guide. iPF685User's GuideError Message Messages regarding paper666Downloaded from ManualsPrinter.com Manuals
