Setting Item Description, InstructionsPaper Details (The type of paperis displayed here.)(*1)Trim Edge First (See "Cutting the Leading Edge of Roll Paper Automatical-ly.") ➔ P.391CutDustReduct. If you choose On, a line will be printed at the cut position when pa-per cutting is selected. This option reduces the amount of debris giv-en off after cutting. It also helps prevent adhesive from sticking tothe cutter and keeps the cutter sharp if you use adhesive paper.(See "Reducing Dust from Cutting Rolls.") ➔ P.393VacuumStrngth Specify the level of suction that holds paper against the Platen.(See "Adjusting the Vacuum Strength.") ➔ P.587Scan Wait Time Specify the time to wait for the ink to dry between each scan (afterthe printhead finishes moving in one direction), in consideration ofhow quickly the ink dries. Also specify the applicable area for the inkdrying time. Select Entire area to apply the ink drying time aftereach scan until the document is fully printed. Select Leading edgeto apply the ink drying time after each scan only in the area 110–140mm from the leading edge. (The applicable length varies dependingon the Print Quality setting.) Note that printing will take longer ifyou specify the Scan Wait Time setting. In particular, when Lead-ing edge is selected, colors may be uneven in the boundary be-tween the areas with and without a drying time.Roll DryingTime Specify the time to wait for the ink to dry for each sheet.NearEndRollMrgnSpecify the minimum margin at the leading edge of roll paper to en-sure better printing quality at the leading edge.Note that if you choose 3mm, it may lower the printing quality at theleading edge and affect feeding accuracy. The printed surface maybe scratched, and ink may adhere to the leading edge. It may alsocause the Platen to become soiled.NearEnd ShtMrgnSpecify a margin at the leading edge of sheets to ensure betterprinting quality at the leading edge.Note that if you choose 3mm, it may lower the printing quality at theleading edge and affect feeding accuracy. The printed surface maybe scratched, and ink may adhere to the leading edge.BordlessOver-sizeSelect the amount of oversize extension of the original during bor-derless printing.Normally, we recommend that you set this to Standard.If it is set to Little, although it will reduce soiling on the back sur-face, white patches may remain on the printed surface.Width Detection Specify this option to print inside boundaries or in other cases whenspecifying a particular starting position for printing.Paper width and skew are not detected if you select Off. If paper isloaded askew, paper jams or Platen soiling may occur.Return Defaults Choose OK to restore Paper Details to the default values.Paper Details Print the paper settings as specified in Paper Details.Keep Paper Type Select On when printing on a particular type of paper regularly.(See "Changing the Type of Paper.") ➔ P.378*1: For information on the types of paper the printer supports, refer to the Paper Reference Guide. (See "Displaying the PaperReference Guide.") ➔ P.365 Types of paper in the printer driver and related software (as well as on the Control Panel ) are upda-ted when you install the printer driver from the User Software CD-ROM or if you update paper information with the Media Config-uration Tool. (See "Updating paper information.") ➔ P.368Menu Settings iPF685User's GuideControl Panel Printer Menu460Downloaded from ManualsPrinter.com Manuals
