53Configure the settings relating to the mail notification [e-Mail]The settings of alarm mail notice, the settings of error report mail (☞ Page 190) and the settings to use themail functions can be configured on this tab.[SMTP server address]Enter an IP address or a name of the SMTP server tosend e-mails. The name of the SMTP server is availa-ble only when "Manual" is selected for "DNS" on the[Basic] tab accessed from the "Advanced setup"menu - the "Network" page of the setup menu. Enterup to 255 alphanumeric characters including hyphens(-) and periods (.).[SMTP port number]Enter the port number of the SMTP server.1 - 65535Default: 25[POP server address]Enter an IP address or name of the POP server to beused for POP before SMTP authentication. The nameof the POP server is available only when "Manual" isselected for "DNS" on the [Basic] tab accessed fromthe "Advanced setup" menu - the "Network" page ofthe setup menu. Enter up to 255 alphanumeric char-acters including hyphens (-) and periods (.).[Authentic method]Select the authentication method to send e-mailsfrom the following.None/ POP before SMTP/ SMTPDefault: None[Authentic method - User name]Enter the user name to be required for the authentica-tion. Enter up to 32 alphanumeric characters exclud-ing "&" listed in the description of "Note".[Authentic method - Password]Enter the password to be required together with theuser name for the authentication. Enter up to 32alphanumeric characters excluding "&" listed in thedescription of "Note". An entered character for thepassword will be displayed as "*" or "•".Note:• Available characters are as follows.A B C D E F G H I J K L M N O P Q R S T U V W XY Z a b c d e f g h i j k l m n o p q r s t u v w x y z0 1 2 3 4 5 6 7 8 9 ! # $ % &‘ ( ) * + ,- . / : ; < = > ?@ [ ¥ ] ^ _ ` { | } ~[Sender’s address]Enter the mail address of a sender. Entered mailaddresses will be displayed in the "From" (sender)line. Enter up to 127 alphanumeric characters includ-ing hyphens (-), periods (.), @, and _.Default: NWDR[Security]Alarm mails or error report mails will be encryptedand transmitted. Authentication method will be set to"SMTP" if it is not set to "Off". Set the user name andpassword for the authentication.Off, SMTP over SSL, STARTTLSDefault: Off[Destination address - Address1 - Address4]Enter the mail addresses of the recipients of the alarmmail and the warning mail (☞ Page 190). Enter up to255 alphanumeric characters including hyphens (-),periods (.), @, and _.Check the desired mail type (Warning/Alarm) to besent.Up to 4 destination addresses can be registered.[Setup via recorder's main monitor]
