126Record imagesLive images can be recorded on the recorder. The image of up to 64 cameras can be recorded in the recorder(up to 128 using the separately sold additional camera kit.)Record images (Schedule recording)Recording can be automatically started and stopped according to a previously specified schedule. Refer topage 34 for schedule recording.Note:• When event recording is triggered by an alarm during the schedule recording, event recording has thehigher priority. Refer to the "Recording mode and its priority" section below for further information about thepriority of the recording mode.• To stop schedule recording, stop the recording on the setup menu. Refer to page 42 for further information.• In case of a network error, the image of the camera where the communication error has occurred will not berecorded. Recording starts when the network error is recovered. If the status in which the communicationwith the camera is disconnected recovers within around 40 seconds, error logs will not be saved.• Schedule-recorded image data will be divided into multiple files every hour on the hour. In that moment,recording may sometimes be interrupted around for 1 second.Recording mode and its priorityThere are 4 recording modes. The recording modes and their priority levels are as follows.When two or more recordings with different recording modes started simultaneously, only recording with thehigher priority will start.Recording mode PriorityEmergency recording 1Event recording 2Schedule recording 3Pre-event recording 4AudioThe audio recording is done at the same time as the image recording. The audio recording can be set for eachcamera. Refer to page 37 for further information.Note:• The audio recording is done at the same time as the image recording. Recording of the audio only is notavailable.RecorderHDDImage dataNetwork cameras[Operation via recorder's main monitor]
