167Auto mode/AUX/WiperSelect and activate the auto mode function/AUX function/wiper function of the camera.Auto mode functionStep 1Select "Auto mode" for the operation mode. Click [▼]button and select an auto mode that you want tooperate.Auto track: The camera will automatically track anobject moving on the screen.Auto pan: The camera direction will automaticallymove (pan) between the start point and endpoint set in advance.Preset sequence: The camera will move (pan) tothe preset positions registered in advance inorder of the preset position number (numericalorder).Patrol: The camera will trace the manuallyrecorded panning pattern.Step 2Click the [Start] button to start the selected automode function of the camera.Click the [Stop] button to turn off the auto mode func-tion.Note:• Refer to the operating instructions of the con-nected camera for further information about theauto mode function of the camera.AUX functionStep 1Change the operation mode from "Auto mode" to"AUX" and select a terminal number of the AUX.Step 2Open: The AUX terminal becomes open.Close: The AUX terminal becomes close.Wiper functionWiper/Washer of WV-SUD638 can be operated.Step 1Change the operation mode from "Auto mode" to"Wiper" and select a wiper function from the following.High: Wipes out continuously. (once per 4 sec-onds)Low: Wipes out continuously. (once per 8 sec-onds)1 shot: Performs high speed wiping (once per 4seconds) 5 times.Washer: Performs the specified washer/wiperoperation.Refer to the operating instruction of WV-SUD638.Step 2When [Start] button is clicked, the selected motionstarts.When [Stop] button is clicked, the motion ends.Note:• The following operation is not available while thewasher is operating.• [Start] and [Stop] operation of "Wiper"• Control of panning, tilting zooming and focusing• [Start] operation of "Auto mode"• [Call] operation of "Preset Position"• It requires the washer operation settings for thecamera side. Refer to the operating instruction ofWV-SUD638.[Operation via PC web browser]
