34Set up recording/events [REC & event]The "REC & event" page has 3 tabs; the [Recording setup] tab, the [Event setup] tab and the [Advanced setup] tab.Recording setup tab [Recording setup]Configure the settings relating to schedule recording. Set the day(s), time table(s), frame rate and image qualityfor recording.■ SchedulesRecording will be performed according to the sched-ules set in advance. Select the day(s) of the week andthe time table(s).[Days to record]Select the day(s) of the week to record. Mark thecheckbox(es) of the day(s) of the week to record.[Schedule to record]6 time tables can be set up for "[Time table1]". Thetime bar indicates 24 hours in steps of 15 minutes.Click the desired position on the time bar to desig-nate the start and end time. When the time is desig-nated, the time bar turns red.Note:• At the default, schedule recording and eventrecording have been set for 24 hours on Timetable1. To delete the designated start and endtime, right-click the timetable.• The recording time table can be set by dragging thestart and end time on the time bar with the mouse.• Be sure to set so that there is no overlap betweenthe 6 time tables. When attempting to set thesame time as already set on another time bar, thetime immediately before or after the overlappingtime will be set.• Within the same time table, event recording haspriority over schedule recording.[Schedule recording]Mark the checkbox (es) if you want to carry out theschedule recording based on the set time bar.[Event recording]Mark the checkbox (es) if you want to carry out eventrecording based on the set time bar. The recorderdoes not record the image even if the alarm occursduring time in which the event recording is not set.[e-Mail]To send an alarm e-mail when an event occurs, markthis item. The event recording must be checked to setthis item.Refer to "Configure the settings relating to the mailnotification [e-Mail]" (☞ Page 53) for the setting ofthe destination.[Panasonic alarm protocol]Mark the checkbox of this item to automatically trans-mit information on an event that occurs to a PC usingthe Panasonic alarm protocol. The event recordingmust be checked to set this item.Refer to "Configure the Panasonic alarm protocolsettings [Panasonic alarm protocol]" (☞ Page 54)for the setting of the address.[Advanced >] buttonThe "Advanced schedule setup" page will be dis-played. In addition to 6 schedule recordings, 6 eventrecordings can be set up. The schedule settings canbe set up to 16 patterns. (☞ Page 35)■ Recording setup (All cameras)Set the recording frame rate and image quality. Thesettings will be applied to all cameras.[Frame rate]Select the recording frame rate.1 ips/ 3 ips/ 5 ips/ 10 ips/ 15 ips/ 30 ipsDefault: 10 ips[Setup via recorder's main monitor]
