47Configure the settings relating to sub monitors [Sub monitor]Set up the sub monitor by selecting the camera images to display, the image display duration, etc.■ Camera title[Display]Set whether to display the camera title on the submonitor.On: Displays the camera titleOff: Does not display the camera titleDefault: On■ Display settingsSet the display sequence for camera images (imageswitching).[Mode]Select how to display images from the cameras.1-screen live sequence: Images from the cameraswill sequentially be switched and displayed on1-screen.4-screen live sequence: Images from the cameraswill sequentially be switched and displayed on4-screen.9-screen live sequence: Images from the cameraswill sequentially be switched and displayed on9-screen.16-screen live sequence: Images from the camer-as will sequentially be switched and displayedon 16-screen.Switch by alarm terminal input: Switches camera1 to 32 to display images on 1-screen accord-ing to the signal input triggered by the terminalalarms from terminal 1 to 32.32Screen: Images from the cameras will be dis-played on 32Screen without switching thescreen.[Keep aspect ratio]Select whether to change the aspect ratio of the dis-played area if the aspect ratio of the image is differentfrom the displayed area.Checked: Keep aspect ratio (Does not change theratio automatically)Not checked: Does not keep aspect ratio(Changes the ratio automatically)Default: Not checked[Duration]Set the interval (duration) for switching cameraimages.3 s/ 5 s/ 10 sDefault: 5 sNote:• The terminal status (N.O. or N.C.) for supplying analarm signal to the alarm terminal depends on thesettings for "Terminal input" of "Advanced termi-nal alarm setup" (☞ Page 40).[Camera selection]Select the cameras to be included in the sequencedisplay.Mark the checkbox next to the desired camera. Theselected cameras will be displayed in numericalorder.Note:• The selected cameras are displayed from the topin the 4-screen, 9-screen and 16-screen livesequence or the 32screen.• The number of selected camera is within the num-ber of split screens, it displays without switchingthe cameras even if the live sequence is selected.[Secret view]Secret view is a function that causes the cameraimage displayed on a 1-screen or the selected cam-era image on a multiscreen on the main monitor to bedisplayed as a black screen on the sub monitor.Determine whether or not to use secret view.On: Enables the secret view function.Off: Disables the secret view function.Default: OffNote:• When using the sub monitor, 64-screen in wideview is not available on the main monitor.• While "1-screen live sequence" is being per-formed, the secret view images will be skipped(not displayed).• The image on the sub monitor may momentarilygo black when images are switched on the mainmonitor.[Setup via recorder's main monitor]
