119AUX operationSets the device connected to the AUX terminal of the camera to the open/closed state.Step 1When displaying the images on a 4-screen, select thedesired cameras.Step 2Click the [Detail] button.→ The "Camera control [Advanced]" panel will bedisplayed. (☞ Page 113)Step 3Click the page switch button on the right top of thescreen.→ The page will be switched to 2/2.Step 4Click the [Open]/[Close] button after selecting theAUX terminal number.When [Open] button is clicked, the AUX terminal ofthe camera becomes open.When [Close] button is clicked, the AUX terminal ofthe camera becomes closed.Note:• The selection of the AUX terminal number is onlyavailable for WJ-GXE500. For cameras other thanWJ-GXE500, the open/close operations only areavailable.Wiper operationOperates the washer/wiper.Step 1When displaying the images on a 4-screen, select thedesired cameras.Step 2Click the [Detail] button.→ The "Camera control [Advanced]" panel will bedisplayed. (☞ Page 113)Step 3Click the page switch button on the right top of thescreen.→ The page will be switched to 2/2.Step 4Select an operation and click the [Start] or [Stop] button.High: Wipes out continuously. (once per 4 sec-onds)Low: Wipes out continuously. (once per 8 sec-onds)1 shot: Performs high speed wiping (once per 4seconds) 5 times.Washer: Performs the specified washer/wiperoperation.Refer to the operating instruction of WV-SUD638.When [Start] button is clicked, the selected motionstarts.When [Stop] button is clicked, the motion ends.Note:• The following operation is not available while thewasher is operating.• [Start] and [Stop] operation of "Wiper"• Control of panning, tilting zooming and focusing• [Start] operation of "Auto mode"• [Call] operation of "Preset Position"• It requires the washer operation settings for thecamera side. Refer to the operating instruction ofWV-SUD638.[Operation via recorder's main monitor]
