150Configure the network settingsThe recorder can be operated using a mouse or from a web browser on a PC (excluding certain functions andsettings). On the following pages, operation from a web browser, setting up the PC and related matters will bedescribed.When operating the recorder using a web browser, it is necessary in advance to configure the network settingsof the recorder and a PC.When the network settings of the PC are as follows, it is unnecessary to configure the settings. It is possible toconfigure the settings and operate the recorder using a web browser after completing the connection.IP address: 192.168.0.2 - 192.168.0.249, 192.168.0.251 - 192.168.0.254Subnet mask: 255.255.255.0Default gateway: 192.168.0.1When the settings are configured differently from the above, configure the network settings of the recorder or aPC.Configure the network settings of the recorderThe network settings of the recorder can be configured on the [Basic] tab of the "Network" page under the setupmenu [Advanced setup].Refer to the chapter relating to the [Basic] tab of "Network" of the setup menu on page 49 for how to operate.Configure the network settings of the PCThe TCP/IP setting of the PC shall be changed to conform to the settings of the recorder. When using therecorder with the default (IP address:192.168.0.250), set the IP address of the PC to "192.168.0.xxx (a numberfrom 2 to 254 except 250 (this recorder))".The settings described in these operating instructions are based on the standard settings for Windows 7. Referto the operating instructions of the respective OS for further information.Step 1Click "Control Panel" on the start menu.→ "Control panel" will be displayed.Important:• Log in to the PC as an administrator.[Setup Network ]
