49Configure the settings relating to network [Network]The settings relating to the network of the recorder are configured on the setup menu - the "Advanced setup"menu - the "Network" page.The "Network" page has [Basic], [e-Mail], [Panasonic alarm protocol] and [NTP/SNMP] tabs.Configure the basic network settings [Basic]The basic settings relating to the network can be configured on this tab.Note:• Enter the address octets and port numbers right-aligned. (Example: When the port number is 80, enter"00080".) The leading zeros are omitted here.■ Network SetupConfigure the network settings of the recorder.[IP address]The IP address of the recorder will be displayed.To change the IP address, click the [▲]/[▼] button.Default: 192.168.0.250 [Camera/PC port]0.0.0.0 [PC port][Subnet mask]Select the subnet mask in accordance with therecorder’s network environment. Enter in the sameway as the IP address.Default: 255.255.255.0 [Camera/PC port]0.0.0.0 [PC port][Default gateway]Select the address for the default gateway in accord-ance with the recorder’s network environment. Enterin the same way as the IP address.Default: 192.168.0.1[Line speed]Specify the line speed for data transmission.Auto: Line speed will be applied automatically.100M-Full: 100 Mbps full-duplex100M-Half: 100 Mbps half-duplex10M-Full: 10 Mbps full-duplex10M-Half: 10 Mbps half-duplexDefault: Auto [Camera/PC port]Auto [PC port]Important:• When the setup menu is closed after changing theline speed, the recorder will automatically reboot.■ DNS SetupThe settings relating to DNS (Domain Name System)can be configured on this tab.[DNS]Determine whether or not to use the DNS.Off: Does not use the DNS.Manual: When using DNS, it is possible to searchIP addresses by host name.Default: Off[Setup via recorder's main monitor]
