To use the ARP and PING commands, you will need to know the printer's MAC address. You can confirm the MACaddress on the Control Panel.1 Check the printer's MAC address.You can confirm the MAC address on the Control Panel as follows:1. On the Tab Selection screen of the Control Panel, press ◀ or ▶ toselect the Settings/Adj. tab ( ).2. Press the OK button.The Set./Adj. Menu is displayed.3. Press ▲ or ▼ to select Interface Setup, and then press the OK button.4. Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.5. Press ▲ or ▼ to select MAC Address, and then press the OK button.Note• If the Tab Selection screen is not displayed, press the Menu button.• You can investigate the MAC address by printing an interface setting report.(See "Printing Interface Setting Reports.") ➔ P.4732 In Windows, open a command prompt, or in Mac OS, start Terminal.3 Execute the following command to add entries to the ARP table for managing IP addresses and correspondingMAC addresses.arp -s [IP address] [the printer's MAC address you have verified]Example: arp -s xxx.xxx.xxx.xxx 00-1E-8F-xx-xx-xxNote• In Mac OS when using Terminal, enter the arp command in the format arp -s xxx.xxx.xxx.xxx 00:1E:8F:xx:xx:xx. For details, refer to the help file for the command line.4 Execute the following command to send the IP address to the printer and configure it.ping [IP address as specified in the ARP command] -l 479Example: ping xxx.xxx.xxx.xxx -l 479Note• In -l, the l is the letter l.• In Mac OS when using Terminal, enter the ping command in the format ping -s 479 xxx.xxx.xxx.xxx. For de-tails, refer to the help file for the command line.Note• The subnet mask and default gateway are set to 0.0.0.0. Use RemoteUI to change the subnet mask and default gate-way to match your network settings.For details on RemoteUI, see "Using RemoteUI." ➔ P.494Configuring the IP Address Using ARP and PING Commands iPF685User's GuideNetwork Setting Initial Settings498Downloaded from ManualsPrinter.com Manuals
