4. Routing the Scanner CableYou will need a mirror positioning tool (FY9-3002-000) to route the scanning cable.Figure 3-517The tool is used in common with other models.To use, loosen the screws, extend the two arms (both front and rear) fully, and tightenthe screws.1) Move the No. 2 mirror mount so that the No. 2 mirror mount pulley shaft q is in viewthrough the long hole in the side plate.Figure 3-5183-26CHAPTER 3 EXPOSURE SYSTEMCOPYRIGHT © 1997 CANON INC. CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)qNote: