G. Function Mode [4]To start function mode, press ‘4’ (keypad) and the OK key in sequence.To select an item, press the number (keypad).• To exeute the mode, press the OK key.You must make sure that the copier is in standby state before executing any of theitems.CHAPTER 11 TROUBLESHOOTINGCOPYRIGHT © 1997 CANON INC. CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON) 11-173Note:No.401402403404405406407408409DescriptionUse it to reset E000, E001, E002, E003, orE800.Use it to execute AE automatic adjustment.Use it to adjust the fixing roller nip.Use it to check the LED lamps on thecontrol panel.Use it to check the activation of thescanning lamp.Use it to check the activation of the pre-exposure lamp.Use it to supply toner at time of installation.Use it to cause the developing assembly torotate idly.Use it to check the operation of the hoppermotor.RemarksTo reset an error code, press theOK key. A press on the OK key willinitialize the code and turn off thepower switch.See p. 11-15.See p. 11-41.A press on the OK key turn on allLED lamps on the control panel (for10 sec).A press on the OK key turns on thescanning lamp (for 3 sec).A press on the OK key turns on thepre-exposure lamp (for 3 sec).A press on the OK key startssupplying of toner from the hopperto the developing assemblyautomatically (for about 6 min): theoperation will stop automatically.This mode ignores the signal fromthe developing toner sensor. If youstart the mode by mistake, be sureto turn off the power switchimmediately.A press on the OK key causes thedeveloping assembly to rotate idly(for about 6 sec).A press on the OK key causes thehopper motor to rotate (for 3 sec).
