6-16 Speed Dialling Chapter 6Using Speed DiallingOnce you have registered fax/telephone numbers for one-touch speed dialling(1 p. 6-3), coded speed dialling (1 p. 6-8), or group dialling (1 p. 6-13), you canbegin to send documents or make telephone calls with speed dialling.Sending a Document With Speed DiallingFollow this procedure to send a document using one-touch speed dialling, codedspeed dialling, or group dialling:1 Load the document, face down in the ADF(1 p. 4-3).• To adjust the resolution and contrast,see pp. 7-2, 7-3.• You may be unable to send if the memoryused (shown in the LCD) is close to100%. To free up space in the FAX’smemory: print, send, or delete anydocuments you no longer need to bestored in memory (1 p. 9-5).2 Enter the one-touch speed dialling button orcoded speed dialling code assigned to the faxnumber or group you want to send to.❏ One-touch speed dialling button:Press the one-touch speed dialling buttonyou want.❏ Coded speed dialling code:Press Coded Dial, then use the numericbuttons to enter the two-digit code youwant.• If you make a mistake, press Stopand repeat this step.• NO TEL # appears if no fax/telephone number or group isassigned to the speed dialling buttonor code you pressed.3 Press Start/Copy to begin scanning forsending, or wait a few seconds for the FAX tobegin scanning automatically.• If you do not want the FAX to beginscanning automatically after a fewseconds, disable the TIME OUT setting(1 p. 14-6).DOCUMENT READYMEMORY USED 0%Ex:(Currently used memory)(Standby to scan)
