Toshiba e-STUDIO2020C Service Handbook

Also see for e-STUDIO2020C: User manual

Contents

e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reservedFIRMWARE UPDATING8 - 46(11) Set the DIP-SW4 on the hole punch control PC board to OFF.Note:When the number of blinks is other than “6” (which indicates that the adjustment value is “0”) atthe section “[A]Checking the hole punch position”, follow the steps of “5.1 Stopping PositionAdjustment” in the MJ-6101 Service Manual to adjust the value to the one that has been setbefore the update.(12) Change the settings of the DIP-SW1 and -SW2 on the hole punch control PC board according tothe model as shown in the figure below.Fig. 8-44(13) Install the rear cover of the hole punch unit.(14) Install the rear lower cover of the hole punch unit.(15) Install the finisher board access cover.[C] Confirmation of the updated dataAfter the updating is completed, check each data version in Setting Mode (08) to confirm that the datawere overwritten properly.P.8-56 "8.4 Confirmation of the updated data"ON1 2 3 4ON1 2 3 4ON1 2 3 4ON1 2 3 4MJ-6101E MJ-6101NMJ-6101F MJ-6101S