| 
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reservedADJUSTMENT3 - 703.9 Adjustment of the developer unit3.9.1 Adjustment of the Auto-Toner SensorWhen the developer material is replaced, adjust the auto-toner sensor.P.3-2 "3.1.2 Adjustment of the Auto-Toner Sensor"3.9.2 Adjustment of the doctor-to-sleeve gapFor the adjustment of the doctor-to-sleeve gap, perform the same procedure for the Y, M, C and Kdeveloper units.Adjustment tool to use: Doctor-sleeve gap jig(1) Take off the process unit from the equipment.(2) Take off the developer unit from the processunit.Service Manual "12.6 Disassembly andReplacement"(3) Take off the developer material cover. Thendischarge the developer material.Note:While reattaching the developer materialcover set the latches securely.Fig. 3-36(4) Loosen 2 doctor blade fixing screws.(5) Insert the doctor-sleeve gap jig to adjust thegap.• Using the sandblasted magnetic roller:Insert the gauge "0.65" of the doctor-sleeve gap jig between the developersleeve and the doctor blade to adjust thegap, and tighten the screws.• Using the knurled magnetic roller:Insert the gauge "0.70" of the doctor-sleeve gap jig between the developersleeve and the doctor blade to adjust thegap, and tighten the screws.Fig. 3-37Developer material coverDeveloper unitDoctor blade |
