6© 2008 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520CERROR CODE AND TROUBLESHOOTING6 - 83[CC61] Punch motor (M3) home position detection error[CC71] Punch ROM checksum error[CC72] Punch RAM read/write error[CC80] Front jogging motor abnormality/Front aligning plate motor abnormality* The [CC61] error will be displays when the [E9F0] error occurs three times in succession orduring the initial operation.MJ-1101 (When MJ-6101 is installed)Is there any paper remaining on the transport path?È ÆYES Remove the paper.NORotate the punch motor (M3). Does it rotate smoothly?È ÆNO Fix the mechanism.YESAre the punch home position sensor (S4) and its wiring correct?È ÆNO Replace the sensor. Correct the wiring.YESIs the wiring between the hole punch control PC board (HP) and punch motor (M3) correct?È ÆNO Correct the wiring.YES1. Replace the punch motor (M3).2. Replace the hole punch control PC board (HP).MJ-1101 (When MJ-6101 is installed)Is the conductor pattern on the hole punch control PC board (HP) open circuited or shortcircuited?È ÆYES Replace the hole punch control PC board (HP).NOReplace the finisher control PC board.MJ-1101 (When MJ-6101 is installed)Is the conductor pattern on the hole punch control PC board (HP) open circuited or shortcircuited?È ÆYES Replace the hole punch control PC board (HP).NOReplace the finisher control PC board.MJ-1030 (Front aligning plate motor abnormality)Is the front aligning plate home position sensor (PI36) normal?È NO Æ Replace the sensor.YESIs the wiring between the finisher controller PC board and the front aligning plate motor (M33)correct?È NO Æ Correct the wiring.YESIs there any mechanical problem with the path of aligning plate?È NO Æ Fix the mechanism.YES1. Replace the front aligning plate motor.2. Replace the finisher controller PC board.
