e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reservedERROR CODE AND TROUBLESHOOTING6 - 54[C150] PFP upper drawer tray abnormality[C160] PFP lower drawer tray abnormalityDoes the tray go up? (Perform the output check: 03-278, 280)||||||||||||ÈNO Æ 1. Check if the connector of the tray-up motor is disconnected.2. Check if any of the connectors CN241, CN242 and CN244 on the PFPboard is disconnected.3. Check if the connector CN349 on the LGC board is disconnected.4. Check if the connector pins are disconnected or the harnesses are opencircuited.5. Check if the conductor patterns on the PFP board and LGC board are shortcircuited or open circuited.6. Replace the tray-up motor.7. Replace the PFP board.8. Replace the LGC board.YESIs the tray-up sensor working? (Perform the input check: 03-[FAX]OFF/[2]/[H], /[8]/[H])|||||||||||||ÈNO Æ 1. Check if the connector of the sensor is disconnected.2. Check if any of the connectors CN241, CN247 and CN248 on the PFPboard is disconnected.3. Check if the connector CN349 on the LGC board is disconnected.4. Check if the slit reaches the sensor.5. Check if the connector pins are disconnected or the harnesses are opencircuited.6. Check if the conductor patterns on the PFP board and LGC board are shortcircuited or open circuited.7. Replace the tray-up sensor.8. Replace the PFP board.9. Replace the LGC board.YES1. Check if the conductor pattern on the LGC board is short circuited or open circuited.2. Replace the LGC board.
