| 
e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reservedADJUSTMENT3 - 16[A] Reproduction ratio of primary scanning direction (Fine adjustment of polygonal motorrotation speed (Printer))(1) While pressing [0] and [5] simultaneously, turn the power ON.→ (Adjustment Mode)(2) Press [98] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the 2nddrawer.)(3) Measure the distance A from the 1st line to the 21st line of the grid pattern.(4) Check if the distance A is within 200±0.5 mm.(5) If not, use the following procedure to change values and measure the distance A again.(Adjustment Mode) → (Key in the code [401]) → [START]→ (Key in a value (acceptable values: 0 to 255))→ [ENTER] or [INTERRUPT] (Stored in memory)→ “100% A” is displayed.→ Press [98] → [FAX] → (A grid pattern is printed out.)* The larger the adjustment value is, the longer the distance A becomes (approx. 0.08 mm/step).[B] Primary scanning data laser writing start position (Printer)(1) While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)(2) Press [98] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD from the 2nddrawer.)(3) Measure the distance B from the left edge of the paper to the 6th line of the grid pattern.(4) Check if the distance B is within 52±0.5 mm.(5) If not, use the following procedure to change values and measure the distance B again.(Adjustment Mode) → (Key in the code [411]) → [START]→ (Key in a value (acceptable values: 0 to 255))→ [ENTER] or [INTERRUPT] (Stored in memory)→ “100% A” is displayed→ Press [98] → [FAX] → (A grid pattern is printed out.))* The larger the adjustment value is, the longer the distance B becomes (approx. 0.04 mm/step).(6) After the adjustment for the code 411 is completed, apply the same adjustment value for thecode 410.(Adjustment Mode) → (Key in the code [410]) → [START]→ (Key in the same value in the step 5 above)→ Press [ENTER] or [INTERRUPT] (Stored in memory).Note:Make sure the first line of the grid pattern is printed out since the line is occasionally vanished. |
