e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reservedERROR CODE AND TROUBLESHOOTING6 - 86[CCF1] Tray safety switch abnormality[CDE0] Paddle motor abnormality[CE00] Communication error between finisher and puncher unit[CE00] Punch communication errorMJ-10301. Check if the connector J110 on the finisher controller PC board is disconnected from thetray safety switch (SW2) or the harnesses are open circuited. Correct if any.2. Check if the connector J114 on the finisher controller PC board is disconnected from thestack tray shift motor (M2) or the harnesses are open circuited. Correct if any.3. Replace the tray safety switch4. Replace the stack tray shift motor.5. Replace the finisher control PC board.* You receive a [CDE0] error when the [ED15] error occurs three times in succession or duringthe initial operation.MJ-1101Is there any mechanical problem with the paddle is rotated?È ÆYES Fix the mechanism.NOIs the harness between the paddle motor (M8) and the finisher control PC board (CN6)disconnected or open circuited?lÈÆYES • Reconnect the connector securely.• Replace the harness.NO1. Replace the paddle motor (M8).2. Replace the finisher control PC board.MJ-1030 (When MJ-6004 is installed)Is the problem solved by turning OFF and ON the power of the equipment?È YESÆ End.NOIs the wiring between the finisher controller PC board and punch controller PC board correct?È NO Æ Correct the wiring.YES1. Replace the finisher controller PC board.2. Replace the punch controller PC board.MJ-1101 (When MJ-6101 is installed)Is the harness between the hole punch control PC board (HP) and the finisher control PCboard disconnected or open circuited?È ÆYES Replace the harness. Correct the wiring.NOIs the conductor pattern on the hole punch control PC board (HP) open circuited or shortcircuited?È ÆYES Replace the hole punch control PC board (HP).NOReplace the finisher control PC board.
