Toshiba e-STUDIO2020C Service Handbook

Also see for e-STUDIO2020C: User manual

Contents

e-STUDIO2020C/2330C/2820C/2830C/3520C/3530C/4520C © 2008 - 2011 TOSHIBA TEC CORPORATION All rights reservedERROR CODE AND TROUBLESHOOTING6 - 46[EA70] Stack exit belt home position error / Stack slider home position errorMJ-11011. Check if the connector CN11 on the finisher controller PC board is disconnected from the stackbelt exit home position sensor (S9) and the harnesses are open circuited. Correct if any.2. Is the harness between the stack transport motor (M5) and the finisher control PC board (CN10)disconnected or open circuited?3. Replace the sensor.4. Replace the finisher controller PC board.MJ-10311. Check if the connector J111 on the finisher controller PC board is disconnected from the stackedging HP sensor (SR8) or the harnesses are open circuited. Correct if any.2. Check if the connector J111 on the finisher controller PC board is disconnected from the stackslide motor (M4) or the harnesses are open circuited. Correct if any.3. Replace the stack slider HP sensor.4. Replace the stack slide motor.5. Replace the finisher controller PC board.